Bison IPI ST Series Installation Instructions Manual

————— Installation Instruction Manual —————
Wall mount structures require a minimum ceiling and wall height as well as an acceptable wall mounting
surface. Brick, block, or poured concrete walls are superior. It is inadvisable to mount structures to walls
with wood or steel studs unless additional work approved by an engineer is done to provide additional
support. Bison does not provide wall anchors with any structure. The purchaser assumes liability for
the installation of any wall mounting structure. Consult a professional architect, engineer, or contractor
to determine safe methods of installation to your facility's wall construction.

Inspect all contents prior to installation. Report any missing parts to dealer immediately.

Read all instructions before proceeding.
1. Using the Wall Board Layout Diagram, determine which pre-drilled holes to use on the wall boards.
Using a hammer, install the Flanged Elevator Bolts into the back of each wall board in the appropriate
holes. See Figure 1.
Date: 02/26/14 Rev: 10
S
TATIONARY
B.A. N.J.C.
S
TRUCTURE
CAUTION !!!
FIGURE 1
File: STSeries.mp;900inst.dwg Ref#: 950159