Network Configuration - Uplink L3-5200 Installation & User Manual

NETWORK CONFIGURATION

All settings in the 5200 can be changed by plugging a standard touchtone telephone
into the PHONE port and using a simple voice prompt menu. To access the menu,
follow these steps.
Unplug your alarm system from the 5200 and plug in a touchtone telephone. The
phone should connect to the PHONE port on the 5200.
Pick up the phone, and whether or not you hear dial tone, press *** (press * three
times on the phone).
You will hear a voice prompt: "Enter a menu option."
Enter any of the following commands. After entering a new setting, such as changing
the IP address, press # to return to the main menu.
To do this
Toggle between static
and dynamic IP mode
Check or change
the adapter's current
IP address
Check or change the
network mask (subnet)
Check or change the
gateway address
7
®
5200
Press Then press this
9, then # to return to
01
the main menu
The voice will read off the
adapter's current IP address. Type
in a new IP address if a static
02 address is desired, using 3-digit
octets. For example, to set the IP
address as 192.168.1.20, enter
"192168001020", then press #.
The voice will read off the adapter's
current subnet. Type in a new
subnet if desired, using 3-digit
03
octets. For example, to set the
subnet address as 255.255.255.0
enter "255255255000", then press #.
The voice will read off the adapter's
gateway. Type in a new gateway if
desired, using 3-digit octets. For
04
example, to set the gateway as
192.168.1.1, enter "192168001001",
then press #.
Notes
In order to change the IP
address, the adapter must
be set to static IP mode first.
The adapter must be set to
static IP mode first.
The adapter must be set to
static IP mode first.