Connections Used - Uplink L3-5200 Installation & User Manual

CONNECTIONS USED

LAN (RJ45 included) ....................
PHONE (RJ11) .............................
POWER ........................................
1. Connect one end of an RJ45 Ethernet cable to the "LAN" port of the 5200 and
connect the other end to the Internet Router or Modem in the premises
NOTE: THE 5200 MAY BE LOCATED BY THE ALARM SYSTEM OR BY THE
ROUTER. ADDITIONAL CABLING, NOT INCLUDED, MAY BE NECESSARY.
2. Connect the power adapter to the "POWER" and plug the adapter into a wall outlet.
The 5200 may also use other sources of 12V DC power such as an alarm system
or battery instead of the included transformer. The 5200 will use as much as 300mA
when the device is communicating an alarm signal.
3. Configuration and registration of the device may take 2 minutes. Do not proceed
until the LED on the right is lit steady green with an occasional flash of amber.
NOTE: DO NOT POWER CYCLE THE 5200 DURING SYSTEM BOOT UP.
4. Connect the alarm system to the "PHONE" port of the 5200 using a standard two-
wire RJ11 cord (only tip & ring required).
5. IF using an RJ31X connection, use the in-line adapter and cord included with the
5200 (which will close the Tamper Loop)
a. Plug the short black cord extending from the in-line adapter into the "PHONE"
port on the 5200
b. Plug the RJ31X cord into the opposite end of the adapter
c. RJ11 cable into the port "PHONE"
5
®
5200
Connection to an internet router
Connection to alarm system
Power adapter connection or 12V DC power