Table of Contents
Advertisement
Installation -
Installation
Before installing your camera, you must read the following cautions.
1.
The mounting surface must withstand five times the camera weight.
2.
Do not let the cables get caught in improper places or the electric line cover can be damaged. This may
cause a short or fire.
3.
Using the mounting template or the camera itself, mark and drill the necessary holes in the mounting
surface.
Installing your camera:
1.
Pass wires through and make all necessary connections.
See the 'Cabling' section for more information.
2.
Using the included screws and anchors, secure the camera
to the mounting surface.
3.
Loosen the pan/tilt stopper screw and adjust the
camera's angle as needed.
4.
Use the test video cable for a local preview
of the camera's view.
5.
Use the T-W toggles at the bottom of the
camera to adjust the zoom.
WIDE
Zoom Out
Zoom In
TELE
Reset Button
T-W Jog Button
Test Video Output
SD Card Slot
Reset to the Factory Default
Press the reset button for 5 seconds to return the
setup to the factory default.
Warning:
If you press the 'Reset' button, you will lose all
setting data. If needed, please, make a note for
further installation.
7
Advertisement
Table of Contents
