Troubleshooting Guide - Faber FEG4916F Instruction Manual

Troubleshooting Guide

Unit does not power on using the remote control
Remote control is not synced
Remote batteries are dead
Receiver batteries are dead
Pins on the 8-pin connector are bent
Receiver is surrounded by metal - transmission range
is reduced
RF interference - transmission range is reduced
Receiver is defective
Remote is defective
No ignition, no tone
Remote and receiver are not synced
Receiver has no power
Receiver is defective
No Ignition; One continuous 5 second tone (7 short beeps might be heard prior to the 5 second tone)
Loose wire
Bent pins on 8 wire connectors
Receiver requires power cycling
Receiver is defective
Valve is defective
65
Remote must learn new code
Press and hold the receiver's reset button until you
hear 2 acoustic signals . After the second longer
acoustic signal, release the reset button and within the
subsequent 20 seconds, press
on the remote handset until you hear an additional long
acoustic signal confirming the new code is set .
• NOTE: if 15-20 seconds pass while pressing and
holding (down arrow) and a long single tone is heard,
confirm the sticker label (see below) on the remote
handset and back of the receiver are both blue, or
remote sticker is black, and the receiver sticker is
green .
Replace batteries (2 × AAA batteries)
Replace batteries (2 × AA alkaline batteries)
Inspect the pins and straighten as needed
Bring remote closer to receiver
Change the position of the antenna
Replace receiver
Ensure labels on back of remote and receiver match in
color . Blue and blue, green to black .
Replace remote if needed and reprogram code .
See above to ensure remote has correct code to
receiver .
Check power to receiver .
Replace receiver
Inspect wires, tighten as necessary
Inspect pins, straighten as necessary
Reset receiver and resync remote
Replace receiver
Replace valve
(down arrow) and hold
FaberFires.com