Receiver And Remote Batteries; Pairing Remote With Fireplace Receiver - Faber FEG4916F Instruction Manual

Receiver and Remote Batteries

Remote Control Batteries
• 2 × AAA (alkaline recommended) .
• Low battery indicator on handsets with display .
is displayed, is dis-
• Battery replacement is recommended every
or button.
2 years .
button. , ,
displayed shortly,
or but-
button.
CAUTION: DO NOT USE a screwdriver or other metallic object to remove the batteries from
the battery box! This could cause a short circuit to the system .
is displayed, is dis-
or button.
button. , ,

Pairing Remote with Fireplace Receiver

is displayed
or but-
Your remote will come paired with the fireplace
receiver and will be ready for operation out of the box .
button.
In the event of remote or receiver replacement, use
the following procedure to pair the remote with the
receiver:
1 . Press and hold the receiver's reset button (see
Figure 1) until you hear two (2) beeps . The first
beep is short, and the second beep is long . After
the second beep, release the reset button .
, and Daily Timer ( ,
2 . Within the subsequent 20 seconds, press the
button on the handset until you hear two additional
short beeps confirming the code is set . If you hear
one long beep, this indicates the code learning
sequence has failed or the wiring is incorrect .
se-
2 BURNER FEATURE
ND
The latching solenoid valve will open automatically after ignition
or after switching the system OFF, so that the maximum flow of
gas is supplied to both burners assisting with the ignition process.
After pressing the button for the 2
seconds in the ON direction until the max. position is reached.
ON:
▪ To switch a burner ON, press the
AM
button.
PM
▪ displayed.
ON
OFF
1 2
OFF:
▪ To switch the burner OFF, press the
▪ disappears.
NOTE: The latching solenoid valve cannot operate manually. If
the Receiver battery runs down it will remain in the last
operating position.
ECO MODE
ON:
▪ Press
AM
▪
OFF:
1. Press
2. Press
Mode.
3. Press
Mode.
4. Press
Mode.
CIRCULATING FAN OPERATION
Circulating fan has 4 speed levels from
low (1 bar) to high (4 bars).
AM
ON / SETTING:
1. Press
flashes.
2. Press
and
3. To confirm setting either press
ton or wait (
OFF:
▪ Press
bars disappear.
NOTE: SETTING only. If the fan was not switched OFF after
last use, it starts automatically 4 minutes after ignition
at maximum speed and goes to the last set level after
10 seconds. The fan stops 10 minutes after the gas is
OFF or at pilot.
FOR OEM USE ONLY
Receiver Batteries
• 4 × AA (alkaline ONLY)
• Low battery indicator: Frequent beeps for 3 seconds
when motor turns .
Burner the motor will turn 7
nd
• If A/C adaptor is not used, battery replacement is
recommended at the beginning of each heating
season as part of the yearly service check .
button.
Figure 1
button to enter Eco Mode.
is displayed.
button.
or button to enter Manual
button to enter Thermostatic
button to enter Program
button and hold until
button to increase fan speed
button to decrease fan speed.
displayed).
button until all 4 speed level
but-
20