Wand Emulation Plug & Play
IBM 4683 Ports 5B, 9B, and 17 Interface
In Wand Emulation mode, the imager decodes the bar code then sends
data in the same format as a wand imager. The Code 39 Format
converts all symbologies to Code 39.
The Same Code Format transmits UPC, EAN, Code 128 and
Interleaved 2 of 5 without any changes, but converts all other
symbologies to Code 39.
The Wand Emulation Plug & Play Code 39 Format bar code below
sets the terminal ID to 61. The Wand Emulation Plug & Play Same
Code Format bar code sets the terminal ID to 64. These Plug & Play
bar codes als
o set the Transmission Rate to 25 inches per second,
O
utput Polarity to black high, and Idle State to high. (If you want to
change
the terminal ID only, without changing any other imager
settings, refer
to Term
Scan one of the
follow
for
IBM 4683 Port 5B, 9B, or 17.
Note:
After scanning o
workstation.
inal ID
in Chapter 2.
ing "Plu
g and Play" codes to program the 7837
ne of these codes, you must power cycle
Chapter 1: Getting Started 1-19
the