Heater Installation - Sawo ARIES ARI3-45Ni2-CNR Manual

HEATER INSTALLATION

The heater can be placed wherever in the sauna, but for safety and convenience, follow
the minimum safety distances as provided below (See page 9). Follow the cubic
volumes given in the Technical Data (See page 30). Do not install the heater to the
floor or wall niche. Do not install more than one heater in a sauna room unless you follow
the special instructions for twin-heater installations. In most countries, there is a law that
requires heaters to be screwed to the floor.
The heater gets very hot. To avoid the risk of accidental contact with the heater, it is
recommended that a heater guard be provided.
The cable used for sauna wiring must be HO7RN-F type or its equivalent. A certified
electrician must do the installation of the heater to ensure safety and reliability. Improper
electrical connection can cause electric shock or fire. Refer to the electrical diagram (See
page 16).
ВНИМАНИЕ!
Перед установкой печи вытащите
из нагревательных
весь картон – он предназначен
для защиты
транспортировке.
Рис. 2
Минимальные безопасные расстояния (мм)
Minimum safety distances (mm)
Fig. 2
элементов
исключительно при
MIN. mm
45
NOTE!
Remove the carton from the heating
elements before installing the heater as
it is only intended to protect them during
shipment.
A
B
ARI3-45Ni2-CNR
ARI3-60Ni2-CNR
ARI3-75Ni2-CNR
ARI3-90Ni2-CNR
A
100 1900
100 1900
100 1900
100 1900
РУССКИЙ | ENGLISH
B
9