Heater Installation - Sawo PHOENIX PNX3-45Ni2 Manual

HEATER INSTALLATION

The heater can be placed wherever in the sauna, but for safety and convenience, follow
the minimum safety distances as provided below (See page 9). Follow the cubic
volumes given in the Technical Data (See page 32). Do not install the heater to the
floor or wall niche. Do not install more than one heater in a sauna room unless you follow
the special instructions for twin-heater installations. In most countries, there is a law that
requires heaters to be screwed to the floor.
The heater gets very hot. To avoid the risk of accidental contact with the heater, it is
recommended that a heater guard be provided.
The cable used for sauna wiring must be HO7RN-F type or its equivalent. A certified
electrician must do the installation of the heater to ensure safety and reliability. Improper
electrical connection can cause electric shock or fire. Refer to the electrical diagram (See
page 16).
ВНИМАНИЕ!
Перед установкой печи вытащите
из нагревательных
весь картон – он предназначен
для защиты
транспортировке.
Минимальные безопасные расстояния (мм)
Рис. 2
Minimum safety distances (mm)
Fig. 2
A
A
элементов
исключительно при
MIN. mm
A
NOTE!
Remove the carton from the heating
elements before installing the heater as
it is only intended to protect them during
shipment.
B
PNX3-45Ni2
PNX3-60Ni2
PNX3-75Ni2
PNX3-90Ni2
45
PNX6-90Ni2
A B
100 1900
125 1900
125 1900
150 1900
150 1900
РУССКИЙ | ENGLISH
9