Olsberg OSORNO Installation Instructions Manual page 46

Instruction manual
EN
for the user
Combustion air slide position
ZU
AUF
CLOSED
OPEN
FERMÉE
OUVERTE
Fig. 3.4 Combustion air slide valve
Adjusting the combustion air
Operating lever Ignition position
"OPEN"
Operating lever Nominal heat output with logs or wood
"1/2 OPEN" briquettes
Operating lever Ember retention / prevents the room from
"CLOSED" cooling down
● Since the secondary air also contributes to pane cleanliness, the
operating lever must be set to at least „1/2 OPEN" during combus-
tion. This also applies to low-load operation!
● In heating mode, with embers only or when not in use, set the
operating lever to „CLOSED"! This keeps the embers burning for as
long as possible and prevents the room in which the stove is ins-
talled from cooling down.
46
Heating
Before putting on the fuel
● Empty the ash box or combustion chamber in good time!
Otherwise, the combustion air supply is obstructed and/or dama-
ge to the grate device is possible.
● Remove the ash box only for emptying!
● Clean the ash box compartment regularly with the ash box remo-
ved to remove any ash that may have fallen beside it (e.g. with a
vacuum cleaner).
Add fuel
● Only put on the amount of fuel that is needed according to the
heat requirement.
kg
OSORNO
max. 2,2 kg
(gesamt | total)
OSORNO S
max. 1,6 kg
(gesamt | total)
Fig. 3.5 Adding fuel
● Open the combustion chamber door slowly when refilling, other-
wise heating gases may escape!
● When adding fuel, never fill more than a maximum of
2.2 kg (OSORNO) or 1.6 kg (OSORNO S) of fuel into the combusti-
on chamber. The maximum filling height of the fuel in the com-
bustion chamber is 20 cm! If you put more fuel in the combustion
chamber, there is a risk of overheating!
OSORNO / OSORNO S
We reserve the right to make technical changes