Device Care; Cleaning The Outer Casing; Cleaning The Touchscreen; Restarting The Device - Garmin ZUMO XT2 Owner's Manual

Device Care

Avoid dropping your device.
Do not store the device where prolonged exposure to extreme temperatures can occur, as it can cause
permanent damage.
Never use a hard or sharp object to operate the touchscreen as this may result in damage.

Cleaning the outer casing

Avoid chemical cleaners and solvents that can damage plastic components.
1 Clean the outer casing of the device (not the touchscreen) using a cloth dampened with a mild detergent
solution.
2 Wipe the device dry.

Cleaning the Touchscreen

1 Use a soft, clean, lint-free cloth.
2 If necessary, lightly dampen the cloth with water.
3 If using a dampened cloth, turn off the device and disconnect the device from the power.
4 Gently wipe the screen with the cloth.

Restarting the Device

You can restart your device if it stops functioning.
Hold the power button for 12 seconds.

Removing the Device, Mount and Suction Cup

Removing the Device from the Mount

1 Press the release tab or button on the mount.
2 Tilt the top of the device downwards and lift the device from the mount.

Removing the Mount from the Suction Cup

1 Turn the device mount to the right or left.
2 Apply pressure until the socket on the mount releases the ball on the suction cup.

Removing the Suction Cup from the Windscreen

1 Flip the lever on the suction cup towards you.
2 Pull the tab on the suction cup towards you.

Changing the Fuse in the Fuse Cable

When replacing the fuse, verify that the replacement fuse is fully inserted into the fuse housing. The vehicle
power cable does not work unless it is assembled correctly.
If your device does not charge in your vehicle, you may need to replace the fuse located on the red system
power cable.
1 Lift up the cover from the top of the fuse housing.
2 Insert a new 3 A fuse.
3 Replace the cover on the fuse housing.
52
NOTICE
NOTICE
NOTICE
Device maintenance