Table of Contents
Advertisement
Avoiding a road
1 Select
> Navigation > Custom Avoidances.
2 If necessary, select Add Avoidance.
3 Select Add Avoid Road.
4 Select the starting point of the section of road to avoid and select Next.
5 Select the ending point of the road section and select Next.
6 Select Done.
Disabling a custom avoidance
You can disable a custom avoidance without deleting it.
1 Select
> Navigation > Custom Avoidances.
2 Select a created avoidance.
3 Select
> Disable.
Deleting custom avoidances
1 Select
> Navigation > Custom Avoidances >
2 Select an option:
• To delete all custom avoidances, select Select All > Delete.
• To delete one custom avoidance, select the avoidance and select Delete.
Navigating off road
If you are not following roadways as you navigate, you can use Straight Line mode.
Select
> Navigation > Calculation Mode > Straight Line > Save.
The device ignores roads and calculates routes using straight lines between destinations.
Fuel tracking
You can set your device to estimate your fuel usage, warn you when you approach the maximum estimated
fuel distance, and suggest fuel stops based on your estimated fuel range. When fuel tracking is enabled,
indicates the current fuel status.
White: fuel tracking is disabled, or the device is not connected to the motorcycle mount.
Green: the estimated fuel range is above the fuel tank warning level.
Yellow: the estimated fuel range is below the fuel tank warning level.
Red: the estimated distance remaining on the tank is 0.
Enabling fuel tracking
Before you can enable fuel tracking, the device must be placed in the motorcycle mount.
When you enable fuel tracking, a fuel gauge appears on the trip computer
page 27).
1 Fill your fuel tank.
2 Select
> Fuel Settings > Fuel Tracking.
3 Select Distance Per Tank.
4 Enter the distance the vehicle travels on a tank of fuel and select Done.
Navigating to your destination
.
(Viewing the trip information page,
17
Advertisement
Table of Contents
