Table of Contents
Advertisement
Before You Begin
Safety Notes
Read all the following safety notes before working with this product. These notes contain important
information about the installation, usage, and maintenance of this product.
This product contains no user-serviceable parts. Any reference to servicing in this User
Manual will only apply to properly trained, certified technicians. Do not open the housing
or attempt any repairs.
All applicable local codes and regulations apply to proper installation of this product.
Personal Safety
•
Avoid direct eye exposure to the light source while the product is on.
•
Always disconnect the product from the power source before cleaning.
•
Always connect the product to a grounded circuit to avoid the risk of electrocution.
•
Do not touch the product's housing when operating because it may be very hot.
Mounting and Rigging
•
The luminaire is intended for professional use only.
•
The product should be positioned so that prolonged staring into it at a distance closer than 3.3 ft
(1 m) is not expected.
•
Do not submerge this product (IP67). Temporary outdoor operation is fine.
•
When using this product in an outdoor environment, use IP65 (or higher) rated power and data
cables. Secure unused power and data ports with attached IP65 covers.
•
CAUTION: When transferring product from extreme temperature environments, (e.g., cold truck to warm,
humid ballroom) condensation may form on the internal electronics of the product. To avoid causing a
failure, allow product to fully acclimate to the surrounding environment before connecting it to power.
•
Not for permanent outdoor installation in locations with extreme environmental conditions. This
includes, but is not limited to:
•
Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
•
Locations where the normal high or low temperatures exceed the temperature ranges in this manual.
•
Locations that are prone to flooding or being buried in snow.
•
Areas where the product will be subjected to extreme radiation or caustic substances.
•
Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
•
Make sure there are no flammable materials close to the product when operating.
•
When hanging this product, always secure to a fastening device using a safety cable.
Power and Wiring
•
Make sure the power cord is not crimped or damaged.
•
Always make sure to connect this product to the proper voltage in accordance with the
specifications in this manual or on the product's specification label.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
•
Never connect this product to a dimmer pack or rheostat.
•
Make sure to replace the fuse with another of the same type and rating.
•
Never disconnect this product by pulling or tugging on the power cable.
•
If the external flexible cable or cord of this product is damaged, it shall be replaced with a special
cable or cord exclusively available from the manufacturer or its service agent.
•
The light source contained in this luminaire shall only be replaced by the manufacturer, its service
agent, or a similarly qualified person.
Operation
•
Do not operate this product if there is damage on the housing, lenses, or cables. Have the damaged
parts replaced by an authorized technician at once.
•
Do not cover the ventilation slots when operating to avoid internal overheating.
•
The startup temperature range is -4 °F to 113 °F (-20 °C to 45 °C).
•
The operating temperature range is -40 °F to 113 °F (-40 °C to 45 °C).
•
The storage temperature range is -40 °F to 167 °F (-40 °C to 75 °C).
•
Do not start, operate, or store the product outside of the above temperature ranges.
•
In the event of a serious operation problem, stop using this product immediately!
If this Chauvet product requires service, contact Chauvet Technical Support.
Ilumipod SL User Manual Rev. 4
2
Advertisement
Table of Contents
