Remote Device Management (Rdm); Beam-Shaping Filters - Iluminarc ILUMIPODSL User Manual

Hide thumbs Also See for ILUMIPODSL:

Table of Contents

Setup

Remote Device Management (RDM)

Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate

bi-directionally along existing DMX cabling. Check the DMX controller's User Manual or with the

manufacturer as not all DMX controllers have this capability. The Ilumipod SL supports RDM protocol that

allows feedback to make changes to menu map options.

Power input

RDM2go

The Ilumipod SL can be used with the medium, wide, very wide, or asymmetrical beam-shaping filters

(sold separately).

Filter retainer ring

Screws

Follow the instructions below to install the optional filters:

Detach the filter retainer ring by removing the screws attaching it to the fixture.

Place the beam-shaping filter on top of the lenses. Ensure the glossy side of the filter is facing

OUT.

Place back the filter retainer ring on top of the beam-shaping filter.

Screw the filter and the retainer ring back in place.

Ilumipod SL User Manual Rev. 4

Ilumipod SL

Signal

DMX Output

1. Ground

2. Data -

3. Data +

Beam-shaping filter

Signal Connector

1. Ground (black clip)

2. Data -

(green clip)

3. Data +

(red clip)

To other

Ilumipod

products

Table of Contents