Safety Notes; Personal Safety; Mounting And Rigging; Power And Wiring - Iluminarc Ilumipod 42 IP Optic Series User Manual

Introduction
There are no
user serviceable
parts inside this
product. Any reference to
servicing it you may find
from now on in this User
Manual will only apply to
properly ILUMINARC ®
certified technicians. Do
not open the housing or
attempt any repairs
unless you are one of
them.
Please refer to all
applicable local
codes and
regulations for the proper
installation of this product.
Keep this manual
for future
consultation. If
you sell this product to
another user, make sure
that they also receive this
manual.
In the unlikely
event that your
Ilumipod 42 IP
Optic Series fixture may
require service, please
contact ILUMINARC ®
Technical Support.
2

Safety Notes

Please read all the following safety notes carefully because they include important information
on how to install, use, and maintain this product safely.

Personal Safety

· Avoid direct eye exposure to the light source while the fixture is on.
· Always disconnect this product from its power source before servicing.
· Always connect this product to a grounded circuit to avoid the risk of electrocution.
· Do not touch this product's housing when operating because it may be very hot.

Mounting and Rigging

· This product is for outdoor use and it can be submerged (IP67). However, do not
submerge it deeper than 1 m for more than (30) thirty minutes.
· CAUTION: When transferring product from extreme temperature environments, (e.g.
cold truck to warm humid ballroom) condensation may form on the internal electronics
of the product. To avoid causing a failure, allow product to fully acclimate to the
surrounding environment before connecting it to power.
· Do not allow the product to remain pointed straight down.
· When hanging this product, always secure it to a fastening device using a safety cable.

Power and Wiring

· Always make sure that you are connecting this product to the proper voltage, as per the
specifications in this manual or on the product's sticker.
· Never connect this product to a dimmer.
· Make sure that the power input cable is not cracked, crimped, or damaged.
· Never disconnect this product by pulling or tugging on the power input cable.

Operation

· The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate this product
at a higher temperature.
· In case of a serious operating problem, stop using this product immediately!
Ilumipod 42 IP Optic Series User Manual Rev. 6