Setup; Ac Power; Ac Plug; Dmx Linking - Iluminarc ILUMIPODSL User Manual

Hide thumbs Also See for ILUMIPODSL:
Table of Contents

Advertisement

3. Setup

AC Power

The Ilumipod SL has an auto-ranging power supply, and it can work with an input voltage range of 100 to
277 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or fire.
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.

AC Plug

The Ilumipod SL comes with a bare-ended power input cord. Use the table below to wire a plug.
Connection
AC Live
AC Neutral
AC Ground

DMX Linking

The Ilumipod SL will work with a DMX controller using a standard DMX serial connection. A DMX Primer is
available from www.iluminarc.com.
DMX Output
1. Ground
2. Data -
3. Data +
5
Wire (U.S.)
Black
White
Green/Yellow
Signal Connector
1. Ground (black clip)
2. Data -
3. Data +
Wire (Europe)
Brown
Blue
Green/Yellow
(green clip)
(red clip)
Ilumipod SL User Manual Rev. 4
Setup
Screw Color
Yellow or Brass
Silver
Green

Advertisement

Table of Contents
loading

Table of Contents