Lexmark CS737 User Manual page 88

Use printer menus
Menu item
Print Configuration
Font Sharpening
0–150 (24*)
Device Operations
Quiet Mode
Off*
On
Device Operations
Panel Menus
Off
On*
Device Operations
Safe Mode
Off*
On
Device Operations
Clear Custom Status
Device Operations
Clear all remotely‑installed messages
Device Operations
Automatically Display Error Screens
Off
On*
Toner patch sensor setup
Calibration frequency preference
Disabled
Fewest color adjustments
Fewer color adjustments
Normal*
Better color accuracy
Best color accuracy
Toner patch sensor setup
Full calibration
Toner patch sensor setup
Print TPS information page
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Set a text point-size value below which the high‑frequency
screens are used when printing font data.
For example, if the value is 24, then all fonts sized 24 points or
less use the high‑frequency screens.
Change the amount of noise that the printer produces.
Note: Enabling this setting slows down the overall
performance of the printer.
Enable access to the printer menus from the control panel.
Set the printer to operate in a special mode, in which it attempts
to continue offering as much functionality as possible, despite
known issues.
For example, when set to On, and the duplex motor is
nonfunctional, the printer performs one‑sided printing of the
documents even if the job is two‑sided printing.
Erase user‑defined strings for the Default or Alternate custom
messages.
Erase messages that were remotely installed.
Show existing error messages on the display after the printer
remains inactive on the home screen for a length of time.
Set the frequency of performing color calibration and color
alignment.
Run the full color calibration.
Print a diagnostic page that contains toner patch sensor
calibration.
88