Fitting The Camera - Dometic DRIVING SUPPORT PERFECTVIEW CAM44 Installation And Operating Manual

Fitting the camera

8 Fitting the camera
8.1 Tools required
For installation and assembly you will need the following tools:
• Drill bit set (fig. 1 1, page 3)
• Drill (fig. 1 2, page 3)
• Screwdriver (fig. 1 3, page 3)
• Set of ring or open-ended spanners (see fig. 1 4, page 3)
• Measuring ruler (fig. 1 5, page 3)
• Hammer (fig. 1 6, page 3)
• Centre punch (fig. 1 7, page 3)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
• Insulating tape (fig. 1 11, page 3)
• Cable bushing sleeves (optional)
To fasten the cables you may require additional cable binders.
8.2 Fitting the camera
!
CAUTION!
Select a location for the camera and attach it firmly enough so that it
cannot under any circumstances fall off and injure bystanders (e.g. by
being knocked off by branches brushing over the roof of the vehicle).
I
NOTE
If installing the camera alters the vehicle height or the length specified in
the vehicle documents, your vehicle must be inspected by the
appropriate authorities.
Make sure that you are in possession of vehicle documents verifying that
your vehicle has passed this inspection.
20
CAM44
EN