Dometic DRIVING SUPPORT PERFECTVIEW CAM44 Installation And Operating Manual page 19

CAM44
7.3 Creating clean soldering joints
Proceed as follows to solder a cable to the original cables:
➤ Strip approx. 10 mm of insulation from the end of the original cable (fig. b A,
page 6).
➤ Strip approx. 15 mm of insulation from the end of the cable to be connected
(fig. b B, page 6).
➤ Wind the cable to be connected around the original cable and solder the two
cables together (fig. b C, page 6).
➤ Insulate the two cables with insulating tape (fig. b D, page 6).
Proceed as follows to solder two cables together:
➤ Strip the two cables (fig. c A, page 6).
➤ Place a shrink sleeve with a length of approx. 20 mm over the cable (fig. c B,
page 6).
➤ Twist the cables together and solder them (fig. c C, page 6).
➤ Place a shrink sleeve over the soldered point and heat it briefly (fig. c D,
page 6).
EN
Notes on the electrical connections
19