Dometic DRIVING SUPPORT PERFECTVIEW CAM44 Installation And Operating Manual page 14

Safety and installation instructions
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be
performed by qualified specialists.
Observe the following instructions when working with electrical parts:
• When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 3) or a voltmeter (fig. 1 9, page 3).
Test lamps with an illuminant (fig. 1 12, page 3) consume voltages that are too
high and can damage the vehicle's electronic system.
• When making electrical connections, ensure that:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid through sharp-edged ducts without protection (fig. 3,
page 4).
• Insulate all connections.
• Protect the cables from mechanical wear (for example rubbing against existing
cables) using cable binders or insulating tape.
The camera is watertight. However, the seals on the camera cannot withstand a high-
pressure cleaner (fig. 4, page 4). Therefore, you should observe the following
instructions when handling the camera:
• Do not open the camera, as this impairs the watertightness and the function of
the camera (fig. 5, page 4).
• Do not pull on the cables, as this impairs the watertightness and the function of
the camera (fig. 6, page 4).
• The camera is not suitable for use under water (fig. 7, page 4)!
14
CAM44
EN