Dometic DRIVING SUPPORT PERFECTVIEW CAM44 Installation And Operating Manual page 13

CAM44
• When working on the following cables, only use insulated cable terminals, plugs
and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do not use terminal strips.
• Use a crimping tool (fig. 1 10, page 3) to connect the cables.
• Screw the cable for connections to cable 31 (earth)
– Screw on the cable using a cable terminal and serrated washer to one of the
vehicle's earth bolts or
– Screw the cable to the bodywork using a cable terminal and a self-tapping
screw
Make sure there is a good earth connection.
If you disconnect the negative terminal of the battery, the entire data stored in the
volatile memories will be lost.
• The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the corresponding
operating manual.
Observe the following installation instructions:
• Secure the parts of the camera installed in the vehicle in such a way that they
cannot become loose under any circumstances (sudden braking, accidents) or
cause injuries to the occupants of the vehicle.
• Secure any parts of the system covered by the bodywork in such a manner that
they cannot be come loose or damage other parts and cables or impair vehicle
functions (steering, pedals, etc).
• To prevent damage when drilling, make sure there is sufficient space on the other
side for the drill head to come out (fig. 2, page 4).
• Deburr all drill holes and treat them with a rust-protection agent.
EN
Safety and installation instructions
13