H3C LSQM1WCMB0 Installation Manual page 23

..............................................................................
..........
..............................................................................
..........
..................OK!
System is starting...
User interface con0 is available.
Press ENTER to get started.
The displayed information indicates that the auto boot of the LSQM1WCMB0 access
controller module is completed.
Press Enter. The following prompt appears:
<H3C>
This means that the LSQM1WCMB0 is ready to configure.
NOTE:
 During the startup process, the CPLD is automatically upgraded to the latest version. After the
upgrade process, the system displays "The board cpld update successfully, please repower
device." At this prompt, power off and restart the device so that the new CPLD version takes
effect.
 The LSQM1WCMB0 access controller module provides many command views. For detailed
descriptions about the configuration commands and the CLI, refer to H3C WX Series Access
Controllers Command References.
To learn more about access controller software maintenance, see H3C LSQM1WCMB0
Access Controller Module Software Maintenance.
23