Gallagher T10 Installation Notes page 11

FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: Changes or modifications not expressly approved by Gallagher Limited could void the user's
authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
•
•
•
Industry
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
Canada the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Industrie
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
Canada
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
UL
Please refer to document "3E2793 Gallagher Command Centre UL Configuration Requirements" for
Installations
a guide to configuring the Gallagher system to the appropriate UL Standard. Installers must ensure
these instructions are followed to ensure the installed system is UL compliant.
AS/NZS IEC 60839.11.1:2019 Grade 4, Class II
C300400 only
The C300400 variant of the T10 Readers is the only variant that complies with BIS.
HVIN
C300400 T10 MIFARE Reader, Black
C300401 T10 MIFARE Reader, White
C305400 High Sec T10 Reader, Black
C305401 High Sec T10 Reader, White
C300400- T10 MIFARE Reader, Black
C300401- T10 MIFARE Reader, White
3E4288 Gallagher T10 Reader | Edition 11 | March 2023
Copyright © Gallagher Group Limited
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC ID
M5VC30040XA
M5VC30040XB
US - Equipment: com, burg and acc reader
CA - Equipment: com, burg reader
IC ID
7369A-C30020X
7369A-C30020XB
Page 11