Registering The Siren - Panasonic KX-HNS105C Installation Manual

Setup
4
Installation
Install the siren in the desired
location.

Registering the siren

This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the siren, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Note:
R Before registering the siren, make
sure the AC adaptors of the hub and
siren are connected and each
device is powered.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks in green.
2
Siren:
Press and hold M
LED indicator blinks in green
(page 7).
R When registration is complete,
Note:
R To cancel without registering the
siren, press M
on the siren again.
8
HNS105C_(en-en)_0224_ver.020.pdf
OTHER
N until the
the hub sounds one long beep.
N on the hub and
For assistance, visit www.panasonic.ca/english/support
8
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the siren by using
the [Home Network] app, you can
assign a name to your devices and
group them by location. For more
information, refer to the User's Guide
(page 12).
2015/02/24 15:12:14