Table of Contents
Advertisement
Setup
Inserting the
batteries
R USE ONLY Alkaline batteries AA
(LR6) size.
R Do NOT use Manganese/Ni-Cd/
Ni-MH batteries.
R Confirm the polarities (
1
Remove the rear cover by
pressing the upper sides of the
cover (A) and sliding it down (B).
2
Insert the batteries.
8
HNS102HM_(en_en)_0801_ver.021.pdf
,
).
A
B
8
3
Install the rear cover.
R Place it with the "
facing upwards and slide it.
Registering the
motion sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the motion sensor,
it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
" mark
2015/08/03
13:47:58
Advertisement
Table of Contents
