Inserting The Battery; Registering The Window/Door Sensor - Panasonic KX-HNS101 Installation Manual

desired installation area is suitable
to proper operation.
5
Temporary placement
Temporarily place the window/
door sensor in the desired location
and confirm that it operates
properly (page 11).
6
Installation
Install the window/door sensor on
the same position where proper
operation was confirmed
(page 14).

Inserting the battery

R USE ONLY a CR2 Lithium battery.
R Confirm the polarities (
1
Remove the sensor unit cover.
R Lift from the indented area (A)
1
For assistance, please visit http://shop.panasonic.com/support
HNS101_(en_en)_0616_ver.130.pdf
,
and open the sensor unit cover
(B).
2
9
2
Insert the battery.
3
Attach the sensor unit cover.
Registering the
window/door sensor
).
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the window/door
sensor, it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks slowly in green.
2
Window/door sensor:
Remove the sensor unit cover and
press and hold M
LED indicator blinks slowly in
green (page 8).
Setup
OTHER
N until the
9
2015/06/16 22:24:10