Table of Contents
Advertisement
Inserting the battery
R USE ONLY a CR2 Lithium battery.
R Confirm the polarities (
1
Remove the main unit cover.
R Lift from the indented area (A)
and open the main unit cover
(B).
2
1
2
Insert the battery.
3
Attach the main unit cover.
Registering the
sensor
,
).
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Using registration buttons
1
2
Note:
R To cancel without registering the
R If registration fails, the hub sounds
Using the app
When you register the sensor by using
the [Home Network] app, you can
assign a name to your devices and
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks slowly in green.
Sensor:
Remove the main unit cover and
press and hold M
LED indicator blinks slowly in
green (page 8).
R When registration is complete,
the hub sounds one long beep.
sensor, press M
on the sensor again.
several short beeps.
Setup
OTHER
N until the
N on the hub and
9
Advertisement
Table of Contents
