Table of Contents
Advertisement
5
Inserting the battery
R USE ONLY a CR2 Lithium battery.
R Confirm the polarities (
1
2
ケーブルが取り外
し可能の誤解を与
える可能性があり
ますので、次校に
てケーブル有りの
状態に修正致しま
す。
3
HNS103_(en_en)_1120_ver.010.pdf
desired installation area is suitable
to proper operation.
Installation
Install the sensor in the desired
location.
Remove the main unit cover.
R Lift from the indented area (A)
and open the main unit cover
(B).
2
1
Insert the battery.
Attach the main unit cover.
For assistance, please visit www.panasonic.com/support
9
Registering the
sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
,
).
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks in green.
2
Sensor:
Remove the main unit cover and
press and hold M
LED indicator blinks in green
(page 8).
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel registration, press M
on the hub and on the sensor.
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the sensor by using
the [Home Network] app, you can
assign a name to your devices and
group them by location. For more
Setup
OTHER
N until the
N
9
2014/11/19
19:26:58
Advertisement
Table of Contents
