Table of Contents
Advertisement
INFORMATION
- The declared vibration total value(s) and the declared noise emission value(s) have been measured in
accordance with a standard test method and may be used for comparing one tool with another;
− that the declared vibration total value(s) and the declared noise emission value(s) may also be used in a
preliminary assessment of exposure.
WARNING!
− that the vibration and noise emissions during actual use of the power tool can differ from the declared
values depending on the ways in which the tool is used especially what kind of workpiece is processed; and
− of the need to identify safety measures to protect the operator that are based on an estimation of exposure
in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to the trigger time).
•
Wear hearing protection.
3. ASSEMBLY
3.1 ASSEMBLY/ REPLACE OF GUIDE BAR AND SAW CHAIN
Counterclockwise spin the bar
tightening knob, and remove
the side panel cover.
Attached the side panel cover
clockwise spin the tool-firee
chain tensioning to adjust the
tightness of the chain.
Install the guide place and chain,
pay attention to the direction of
the chain.
Rotate the bar tightening knob
for proper bar clamping force.
12
Attached the side panel cover.
Insert the battery pack into the
slot of bottom, check if the safety
lock is locked and then you can
use it
Advertisement
Table of Contents
