Table of Contents
Advertisement
1) To start the tool push and hold the self-locking switch. Then press the power switch to start the operation.
2) To stop the operation, release the trigger and then the self-locking switch.
4.3 PRECAUTIONS FOR CUTTING
1) In some specific cases, the operator may not focus on the work, the operator may trip, fall and cause
serious injury.
a.
Keep calm and work in a planned way
b.
Do not use chain saw in dim and low visibility environment
c.
Please operate your own chain saw
d.
Do not operate the chain saw higher than your shoulder
e.
Watch out for obstacles
f.
When operating the chain saw, please stand in a safe position and keep balance. If you need to
work at height, use a lift or a safe scaffold
2) The running saw chain may hurt the user. Please do not touch the moving saw chain. Otherwise, the user
may be seriously injured.
3) If the saw chain cannot effectively cool down and re tension, the saw chain may jump out of the guide
plate and lead to breakage. These can lead to serious injury and property damage.
a.
Ensure that the saw chain is lubricated properly
b.
Please check whether the tension of the saw chain is proper during operation. If the saw chain is
loose, adjust it in time
4) If the chain saw starts abnormally or runs abnormally in the work, the chain may be in an unsafe state,
which may lead to serious personal injury or property loss. Stop working immediately and contact the
dealer.
5) The chain saw will vibrate when it is running.
a.
Please wear gloves
b.
Stop and rest in time
c.
Consult your doctor if you are in poor health
6) If the running saw chain touches a hard object, it will produce sparks. Sparks can cause fire in
combustible environment, which can cause serious injury and property loss. Do not use chain saw in
combustible environment.
7) When the trigger is released, the chain saw will run for a period of time. It is necessary to wait for the
chain saw to stop completely, otherwise it may cause serious injury.
If the chain saw is used with the tree tensioned, the guide plate may get stuck. Users will lose control of the
chain saw, resulting in serious injury. (Figure 1)
4.4 PRECAUTIONS FOR PRUNING
If the branches under the fallen tree are pruned first, the trunk will not be supported by the branches. Trees
First cut a force relief groove from the tight side (1), and
then cut it into the loose side (2).
14
Advertisement
Table of Contents
