Panasonic WORKIO DP-2310 Operating Instructions Manual page 196

Customizing Your Machine
Fax Parameter Table
* = Factory default setting
No.
151 Email Header Format
152 Sub-address Routing
153
154 Routing Header Format
155 Print Routed Document
156 Print Forward Document
157 Transaction Journal
158 PC Remote Update
160 Default Domain
162 TIFF Viewer URL
163 Routing Header
164 IFax XMT Header
196
Parameter Setting
All
*Subject/
From/To
Off
*Invalid
Valid
TSI Routing *Invalid
Valid
Originator
*Relay
Station
*Inc. only
Always
*Inc. only
Always
*Invalid
Valid
*Invalid
Valid
Invalid
*Valid
None
*English
English+
Japanese
*Off
On
*Included
(Email only)
Not included
Selecting the header information to print when an email is received.
(Normally used for Troubleshooting. It shows the path of the email
transmission before arriving at your machine.)
Selecting whether to automatically route a received fax or email using
ITU-T sub-address.
Selecting whether to route a received fax to a telephone number or an
email address preprogrammed in the Address Book using the
originating fax's Numeric ID (TSI frame information).
Selecting the type of email header to be included in the "From" field of
each routed fax.
Originator : The originating fax machine's TSI will appear in the
"From" field of the routed email.
Relay Station : The routing station's email address will appear in the
"From" field of the routed email.
Selecting whether a received fax to be routed is always printed or only
when the routing operation fails.
Selecting whether a memory received fax or email to be forwarded is
always printed or only when forwarding is incomplete.
Selecting whether the machine sends a transaction journal to the
pre-programmed email address.
Selecting whether the machine will accept commands from an email
application, to:
(a) Program the Internet Parameters
(b) Program the Address Book
(c) Allow retrieval of the Journal
Selecting whether the machine accepts to insert the Default Domain
when entering Manual Number Dialing.
Selecting whether to include the URL address in the email message
body.
Selecting whether to add the Header Print information of the Routing
Station on the top edge of each routed page.
Selecting whether to include the header when sending a document to an
addressee in the same Domain as specified in the Default Domain
parameter. (This is useful when using the machine to scan documents
back to your PC)
Note: When sending to a Domain other than as specified in the
Default Domain parameter, the header will be included
regardless of the selection.
Comments