Panasonic WORKIO DP-2310 Operating Instructions Manual page 193

Fax Parameter Table
* = Factory default setting
No. Parameter
017 Receive Mode
022 Substitute Receive
024 Print Reduction
025 Reduction Ratio
026 Polling Password
027 Polled File Save
028 Stamp at MEM. XMT
031 Incomplete File Save
033 XMT Reduction
037 Receive to Memory
039 PIN Code Access
042 Conf. File Save
043 Password-Transmit
Customizing Your Machine
Setting
Manual Setting the reception mode to automatic or manual.
*Auto
Invalid Selecting whether the machine receives to memory when the recording
paper runs out, toner runs out or the recording paper is jammed.
*Valid
Fixed Selecting print reduction mode.
Fixed : Reduce received document according to setting of Parameter
*Auto
No. 25.
Auto : Automatically determines and reduces the incoming document
to print onto the paper loaded in the machine.
70% Selecting the fixed print reduction ratio from 70% to 100%. This
parameter functions only when the fixed print reduction is selected on
----
Fax Parameter No. 24.
100%
(----) Setting a 4-digit password for secured polling. (See page 48)
*Invalid Selecting whether the machine retains the polled document in memory
even after the document is polled once.
Valid
Invalid Selecting whether the machine stamps the original documents when
storing the documents into memory.
*Valid
(Depends on the Stamp setting on the Control Panel)
*Invalid Selecting whether the machine retains the document in memory if the
document is not successfully transmitted.
Valid
Invalid Selecting whether the machine performs reduction when the
transmitting original is wider than the recording paper used at the
*Valid
receiving machine.
(----) Enter a 4-digit password for printing the received document(s) in
memory by using
MODE SETTING
When
RECEIVE TO MEMORY
selectable on the LCD display. (See page 85)
*None Selecting the access method (Prefix or Suffix) to dial a number with PIN
Code. (See page 90)
Suffix
Prefix
*Invalid Selecting whether the machine saves the confidential polled file even
after the file is polled once.
Valid
*Off Setting a 4-digit XMT-Password and selecting whether the machine
performs and checks the XMT-Password of the receiving station when
On
transmitting. (See page 79)
Comments
RECEIVE TO MEMORY
SELECT MODE
is set to ON, this parameter is not
.
193