IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD, AND RECEIPT.
Step 1:
Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts packed in the carton against the parts list.
If you are missing any parts or unsure how to proceed with assembly, call our Customer Service Center at 1-800-416-3511.
attempt assembly if any parts are missing or damaged.
Place the table top upside down on a flat, non-abrasive surface.
Step 2:
as shown in the diagram. Guide the bolts through the holes in the leg, into the pre-drilled holes in the table top.
2-3 turns.
Repeat for the three legs.
After making any necessary adjustments to the alignment of the parts, use the hex bolt driver to tighten all bolts. Repeat until all
Step 3:
bolts are tight.
Do not over tighten
If you have any questions, please call our Customer Service Center at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered under
our warranty. Please read all instructions carefully before assembly. If you have any questions regarding your assembly, call our
Customer Service Center at 1-800-416-3511.
Attach a leg to the table by using the two bolts and washers
. Over tightening may strip bolts. Cover all bolts with covers. Your table is now ready for use.
B
D
C
Hand tighten only
FOOT CAP
E
A
Page 2
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Do not
PARTS LIST
DESCRIPTION
A
TABLE TOP
B
TABLE LEG
5/16" X 45 MM BOLT
C
Ø8.5 X 1.5 MM
D
BOLT COVER
E
HEX WRENCH
F
FOOT CAP
FACTORY ASSEMBLY
S5-ACK01039K01(AKK09412)
ORDER PART # QTY
AT73552
1
4
AT73553
8
HW0074
8
HW0861
WASHER
8
HW0442
1
HW0008
FC0614
Need help?
Do you have a question about the 272-2191 and is the answer not in the manual?
Questions and answers