Stihl FSA 90 Instruction Manual page 28

English
1 Battery compartment
The battery compartment holds the battery.
2 Locking lever
The locking lever holds the battery in the bat‐
tery compartment.
3 Throttle cable retainer
The throttle cable retainer fastens the throttle
cable on the shaft.
4 Control handle
The control handle is used for operating,
holding and controlling the brushcutter.
5 Retaining latch
The retaining latch unlocks the trigger
together with the trigger lockout.
6 Set wheel
The set wheel is used to select the power
level.
7 Trigger
The trigger switches the brushcutter on and
off.
8 Trigger lockout
The trigger lockout unlocks the trigger.
9 Wing screw
The wing screw secures the handlebar to the
handle support.
10 Handlebar
The handlebar connects the control handle
and the handle to the shaft.
11 Handle
The handle is for holding and controlling the
brushcutter.
12 Shaft
The shaft connects all components.
13 Stop pin
The stop pin blocks the shaft while a cutting
attachment is being mounted.
14 Battery
The battery supplies power to the brushcutter.
15 LEDs
The LEDs indicate the state of charge of the
battery and any faults.
16 Pushbutton
The pushbutton activates the LEDs on the
battery. The pushbutton activates and deacti‐
vates Bluetooth® radio interface (if available).
17 "BLUETOOTH
®
" LED (only for batteries with
)
The LED indicates the activation and deacti‐
vation of the Bluetooth® interface.
# Rating plate with the machine number
28
3.2 STIHL FSA 90 R Brushcutter
and Battery
1
2
#
3
5
6
4
7
12
13 14
1 Battery compartment
The battery compartment holds the battery.
2 Locking lever
The locking lever holds the battery in the bat‐
tery compartment.
3 Control handle
The control handle is used for operating,
holding and controlling the brushcutter.
4 Set wheel
The set wheel is used to select the power
level.
5 Retaining latch
The retaining latch unlocks the trigger
together with the trigger lockout.
6 Trigger lockout
The trigger lockout unlocks the trigger.
7 Trigger
The trigger switches the brushcutter on and
off.
8 Loop handle
For holding and controlling the brushcutter.
9 Barrier bar
Maintains distance between operator's leg
and a metal cutting attachment.
10 Shaft
The shaft connects all components.
3 Overview
1
8
9
10
11
#
15
0458-709-9821-D