Advertisement
Quick Links
SMAL GA ...
SMAL BA ...
(SSI, Binary code)
Description
This manual describes the products of SMAL series.
The purpose of this system is to measure linear displacements on lift system and
on automation systems. The device is composed by a sensor with an integrated
conversion electronic that moving along the magnetic tape, generates a signal
equivalent to an absolute encoder.
The sensor has to be matched with MTAL magnetic tape.
Chapters
1
Safety summary
2
Identification
3
Mounting recommendations
4
SSI interface
MAN SMAL GA_BA E 1.3.doc
SMAL SSI
User manual
(SSI, Gray code)
Pag.1
www.lika.it
www.lika.biz
Advertisement
Related Manuals for Lika SMAL-GA Series
Summary of Contents for Lika SMAL-GA Series
- Page 1 The sensor has to be matched with MTAL magnetic tape. Chapters Safety summary Identification Mounting recommendations SSI interface MAN SMAL GA_BA E 1.3.doc Pag.1 www.lika.it www.lika.biz...
-
Page 2: Safety Summary
The device can be identified by the label's data (ordering code, serial number). This information is listed in the delivery document. For technical features of the product, refer to the technical catalogue. MAN SMAL GA_BA E 1.3.doc Pag.2 www.lika.it www.lika.biz... -
Page 3: Mounting Instructions
Fix the device to the square with M5 screws. Connect the cable. Put the square at the cabin roof adjusting the overhangs according to the desired working position and then fix it. MAN SMAL GA_BA E 1.3.doc Pag.3 www.lika.it www.lika.biz... - Page 4 Install sensor and magnetic tape according to the above figure. The arrow shows positive counting direction. The system doesn't work if mounted incorrectly. connector arrow on magnetic tape MAN SMAL GA_BA E 1.3.doc Pag.4 www.lika.it www.lika.biz...
-
Page 5: Ssi Interface
: 6 x 145 Ω/km, 2 x 87 Ω/km M12 connector: male, frontal side 4.2 LED indicator Description Power supply ON Power supply OFF Description L1 L2 L3 Flash memory error No error Not used MAN SMAL GA_BA E 1.3.doc Pag.5 www.lika.it www.lika.biz... - Page 6 < 300 kHz < 200 m < 200 kHz < 400 m < 100 kHz The time interval between two Clock sequence transmissions must be at least 16µs ( Tp > 16µs ). MAN SMAL GA_BA E 1.3.doc Pag.6 www.lika.it www.lika.biz...
- Page 7 The position reset is possible only at still stand of the sensor (not moving). The reset signal has to be at logic level HIGH (from 10Vdc to 30Vdc) for 100 µsec minimum. MAN SMAL GA_BA E 1.3.doc Pag.7 www.lika.it www.lika.biz...
- Page 8 Chapter 4.1 up to date Lika Electronic Via S. Lorenzo, 25 36010 Carrè (VI) Italy Tel. +39 0445 806600 Fax +39 0445 806699 Italy : eMail info@lika.it www.lika.it World : eMail info@lika.biz www.lika.biz MAN SMAL GA_BA E 1.3.doc Pag.8 www.lika.it...
Need help?
Do you have a question about the SMAL-GA Series and is the answer not in the manual?
Questions and answers