Hot Plug presence detect. Input Signal from add in
card used to enable the reference clock of this slot.
Active low signal, +3.3V_RUN electrical level with a
10k
Power Ground
Please be aware that PCI-e management on the carrier board requires that the add-in card placed on this slot manages the Presence Detect pins
(B31/B17 and A1). More exactly, according to the PCI Express Card Electromechanical Specification v3.0, it is required that these pins are tied together
on the ADD-in Card (at least, it is needed that pin A1 is connected with pin B17 or pin B31).
In case that these pins are not tied together on the add-in card, then the carrier board will not acknowledge the presence of the card in the slot, and will
not enable the reference clock (and the add-in card will not work).