Service Information - CCM Spitfire 2020 Series Owner's Manual

Service Information

• Checking engine oil
The engine can seize if the oil level is low, and this
can lead to accidents.
To ensure that the engine oil level is read
correctly, check the oil level only when engine is
at operating temperature, turned off and with the
motorcycle held upright.
MAXIMUM MARK
MINIMUM MARK
Ensure the oil level is between the maximum and
minimum marks on the left-hand side of the oil
level inspection window.
If the engine oil level is too low, top up with new
oil.
If the engine oil level is too high, have the oil level
corrected by the CCM Services Team.
17
• Adding Engine Oil
To top up engine oil, ensure ground is
-
flat and level.
Remove oil filler cap (1).
-
Top up oil to specified level on the inspection
window. See Technical Information
type.
Re-fit filler cap and wipe any excess oil away
using a cloth.
Always check for signs of leaks after performing
an oil change and do not ride the motorcycle if
anything is seen
• Replacing engine oil and filter
Start the engine and run it until operating
temperature is reached to thin the oil.
Place the motorcycle on its side stand with a
drain pan underneath the oil sump plug.
1
for correct oil
2
Remove the oil sump plug (1) and allow oil to drain
into drain pan.
Beware, engine oil will be hot.
3
Once most of the oil is drained remove the oil
strainer (3) by unscrewing the 2 fastening bolts
and inspect for debris, clean if necessary.
Then remove the oil strainer drain plug (2) and
allow any oil to drain out.