Cleaning - CCM Spitfire 2020 Series Owner's Manual

Cleaning

Proper and frequent cleaning is a vital part of correctly maintaining your
motorcycle. The nature and design of motorcycles leads to many parts being
exposed to the elements, making them much more vulnerable to corrosion.
Extra care and cleaning is needed after each ride to protect the unique chassis
with weld isotherms on display.
Proper cleaning is important, not only to comply with the motorcycles warranty
but also to keep your motorcycle looking good and extending its life.
Before cleaning;
• Cover the muffler outlet with a plastic bag or specific exhaust bung
(after the motorcycle has cooled down) to stop any water or
moisture entering the exhaust system.
•
Ensure that all caps, covers and electrical connectors are tightly and
properly installed.
• Remove very stubborn dirt such as oils or chain lubricants using a
degreasing agent and brush. Never apply these agents to any seals,
bearings, gaskets, sprockets, drive chain or the wheel axles. Always
ensure the degreasing agent and dirt is fully rinsed off with water.
• Ensure all bungs holes are protected in chassis with associated
bungs.
After normal use
• Remove dirt with warm water, a mild detergent and a soft, clean
sponge then rinse thoroughly with clean water.
• Use a toothbrush or similar to get into any hard to reach areas.
41
After riding in the rain or on salt-sprayed roads
• Road salt is extremely corrosive in combination with water. After
each ride in the rain or on salt-sprayed road the following steps
should be carried out.
• Clean the motorcycle with COLD water and a mild detergent after the
motorcycle has cooled down.
• Apply a corrosion protection spray to all metal parts to prevent
corrosion.
Note: Never use warm water as it increases the corrosive action of the road salt.
After cleaning
• Thoroughly dry the motorcycle using a chamois or absorbent cloth.
• Immediately dry and lubricate the drive chain to prevent it from
rusting.
• Always ensure the motorcycle is fully dry before covering.
WARNING
• Avoid using strong acidic wheel cleaners as they can greatly
increase corrosion. If such products are used, thoroughly rinse off
with water. Dry the area immediately and apply a corrosion
protection spray.
• Improper cleaning can damage plastic parts such as fuel tanks,
cowlings and windscreens. Use only a soft cloth or sponge on these
areas and clean water.
• Do not use any harsh chemical products on plastic areas. Be sure not
to use cloths or sponges that have been in contact with any abrasive
or solvent based cleaners.
• Do not use strong cleaners or hard sponges on the motorcycles
windscreen as this area can easily discolour or scratch leading to an
impaired view of the road.
• Avoid the use of high-powered pressure washers as delicate parts
and electrics can be damaged.