Service Information - CCM Roadster 2024 Owner's Manual

Service Information

 Checking engine oil
The engine can seize if the oil level is low, and this can lead to accidents.
To ensure that the engine oil level is read correctly, check the oil level only when
engine is at operating temperature, turned off and with the motorcycle held
upright.
MAXIMUM MARK
MINIMUM MARK
Ensure the oil level is between the maximum and minimum marks on the left-
hand side of the oil level inspection window.
If the engine oil level is too low, top up with new oil.
If the engine oil level is too high, have the oil level corrected by a CCM Approved
Service Centre.
 Adding Engine Oil
To top up engine oil, ensure ground is flat and level.
-
Remove oil filler cap.
-
25
Top up oil to specified level on the inspection window. See Technical Information
for correct oil type.
Re-fit filler cap and wipe any excess oil away using a cloth.
Always check for signs of leaks after performing an oil change and do not ride
the motorcycle if anything is seen.
 Replacing engine oil and filter
Start the engine and run it until operating temperature is reached to thin the oil.
Place the motorcycle on its side stand with a drain pan underneath the oil sump
plug.
1
2
Remove the oil sump plugs (1&2) and allow oil to drain into drain pan.
Beware, engine oil will be hot.