Numatic Hi&Lo NHL15 Original Instructions Manual page 10

Spray extraction machines only
• Use only approved cleaning preparations.
• Use defoamer if necessary.
Use of detergents
When using any detergent with this machine, please ensure you have read the safety data on the container and you are
familiar with the procedures to clear up spills, inhalation, skin and eye contact.
This product complies with the requirements IEC/EN 60335 -2-68.
When moving from one place to another, consider the weight of the machine.
Spray extraction maintenance/fault finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch off and remove the plug from the wall.
Remove the dome and empty the liquid out of the waster water container.
If the waster water container is empty, check that the floor tool wands and hose are not blocked.
If no spray from nozzle the solution tank is empty, refill the solution tank.
Flush the system with clean water after use.
If the machine stops spraying then check the clean water tank level, empty the waste water tank and refill the clean water tank
as necessary.
If the spray nozzles are blocked, they have been designed to be easily cleaned. Undo the spray nozzle cap and clean the
nozzles.
A pin maybe used to clear the blockage.
After use always inspect the machine for damage.
Caution.
Motor Airflow
1060W 49 L/sec
Solution
Pump
Tank
2 Bar 30psi
4 Bar 60 psi
Fault Finding - Wet - Spray Extraction
This machine has been designed to clean carpets and floors.
It must not be used when stood in water.
Suction
2400mm
Size
H x W x D mm
15 L 435 x 425 x 725
Cleaning Range
26.8m
GrossWeight (Full)
35 kgs
Capacity Wet
15 L
Noise
75.6 dB(A)
uncertainty +/- 0.2 dB(A)