Approvals - Siemens S7-400 Equipment Manual

Approvals

Approvals issued
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type plate.
Approvals for shipbuilding are not printed on the device type plate.
Approval for CP and C-PLUG
The following approvals apply to the CP and the supplied C-PLUG.
Documents on the Internet
You will find the declarations of conformity listed below and certificates of the product on the
Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15353/cert)
You can see the current versions of the standards in the relevant certificate, which you will
find on the Internet at the address specified above.
Address for declarations of conformity
The EU and the UK declarations of conformity are available to all responsible authorities at:
Siemens Aktiengesellschaft
Digital Industries
P.O. Box 48 48
90026 Nuremberg
Germany
EU declaration of conformity
The CP meets the requirements and safety objectives of the following EU directives and it
complies with the harmonized European standards (EN) for programmable logic controllers
which are published in the official documentation of the European Union.
• 2014/34/EU (ATEX explosion protection directive)
Directive of the European Parliament and the Council of 26 February 2014 on the
approximation of the laws of the Member States concerning equipment and protective
systems intended for use in potentially explosive atmospheres, official journal of the EU
L96, 29/03/2014, pages 309-356
CP 443-1 Advanced
Equipment Manual, 03/2023, C79000-G8976-C256-07
9
97