Project Engineering - Siemens S7-400 Equipment Manual

Requirements for use

3.3 Project engineering

CPU Article number of
the CPU: 6ES7...
CPU 410-5H ..410-5HX08-0AB0
3) 5)
CPU 410-5H ..410-5HX08-4AB0
3) 6)
CPU 410 SMART ..410-5HN08-0AB0
3)
CPU 410E ..410-5HM08-0AB0
3)
Legend:
+ → The feature is supported / the specified mode is possible.
- → The feature is not supported / the specified mode is not possible.
1) The calculation of the maximum number of SEND/RECEIVE calls that can be used simultaneously per CP is described in
the section "Characteristic data".
2) When operating the CP as a PROFINET IO controller, the multiprocessor mode is not supported, i.e. only the process
image of the assigned CPU can be distributed via the CP (note: this has no influence on communications protocols
operating at the same time in multiprocessor mode).
3) When operating with H-CPUs with a firmware version lower than V6.0, the SSEND / SRECV mode on the SEND/RECV
interface is not supported.
4) The PROFINET IO mode Shared Device requires a CPU as of V5.3.
5) Only for use with PCS 7
6) Only for use with PCS neo
For the maximum possible number of SEND/RECEIVE calls for the CP, refer to the section
Number of simultaneous SEND/RECEIVE calls (Page 24).
3.3 Project engineering
Configuration and downloading the configuration data
It is possible to download the configuration data to the CP via MPI or LAN/Industrial Ethernet.
Downloading is possible over the PROFINET or the gigabit interface of the CP. You require
STEP 7 with additional modules in the following version:
Table 3- 1 Lowest required STEP 7 version
Either STEP 7 V5 or STEP 7 Professional
STEP 7 V5
• STEP 7 V5.6
Security Configuration Tool (SCT) V4.1 ***
•
SCT is used in the configuration of the security function from
within STEP 7.
• Program block library "SIMATIC NET CP" version V5.5.4 **
34
As of CPU a = multiprocessor mode
firmware
b = number of operable CPs
version
c = CPU resources for SEND/RECEIVE jobs
d = LOCK/UNLOCK
e = PROFINET IO
As of V8.0.x +
2)
As of V10 +
2)
As of V8.1.x +
2)
V8.2 +
2)
4)
14 64/64
14 64/64
14 64/64
14 64/64
CP 443-1 Advanced functionality
The functionality of firmware version V3.1.x
can be used.
Equipment Manual, 03/2023, C79000-G8976-C256-07
)
1
+ -
+ -
+ -
+ -
CP 443-1 Advanced