Table of Contents
Advertisement
Mounting
To mount the module, do the following:
1. To remove the module's enclosure cover, press down on the top of the module and pull it away from
the base (Figure 3).
CAUTION: You must be free of static electricity before handling circuit boards. Wear a grounding strap or touch a bare
grounded metal surface to discharge static electricity.
Figure 3. Removing the enclosure
2. Fasten the antenna to the antenna jack (see Figure 2 on page 3).
3. Place the module backplate at the desired location; ensure it is level and mark the three mounting holes
and the wire access area (see Figure 2 on page 3). Be sure to leave at least 12 to 18 in. (30 to 45 cm)
above the backplate for the antenna.
4. Drill holes at the mounting hole and wire access area locations.
5. Install wall anchors and secure the module backplate to the wall with #6 panhead screws.
Press here
7
Advertisement
Table of Contents
