Table of Contents
Advertisement
10
NX-592E-GSM Wireless Gateway
Installation Manual
Programming using the keypad
The wireless gateway needs to know the address of at least one of the LCD keypads. Some commands, such as
getting the zone names for display on the website, will not work if the keypad address is not known. By
default, the wireless gateway assumes a keypad address of 192 (keypad 1, partition 1). If your LCD keypad is
programmed differently (press *94 + installer code to check), you must change the wireless gateway keypad
address. To change the gateway keypad address, do the following:
1. Press *, then 8.
2. Enter the "Go to program" code (the default code is 9, 7, 1, 3). If the code is valid, the keypad display
will prompt you for a device address.
3. Enter the address of the NX-592E (7, 8) then press #. At this point, the keypad display will prompt you
for a programming location to be entered.
4. Enter 0, followed by the # key. Location 0, which is the LCD address will display. The default is 192.
For a list of addresses, see Table 4.
5. To change the LCD keypad address, enter the new address, followed by the * key. The display will
return to the location prompt.
6. To exit this location without changing the data, press the # key.
7. To review the data, repeat the above procedure, pressing the * key without entering data first. If you
attempt to program an invalid entry for a particular segment, the keypad sounder will emit a triple error
beep (beep, beep, beep) and remain in that segment waiting for a valid entry.
8. Press the Exit key to exit this programming level. Press the Exit key again to exit Program Mode.
While in programming mode and not in a location, the number in parentheses is the location you were
previously changing. For example, if the display reads
location 2 was the last location you programmed.
Location 0: LCD keypad address
Certain commands in the module require it to know the location of at least one LCD keypad (if one exists in the
system). If your system has an LCD keypad we recommend that you place it in Partition 1 Keypad 1. This will
allow Location 0 to be left at the factory default. If the LCD keypad is selected as something other than
Partition 1 Keypad 1, program the appropriate address in Location 0. Table shows the address options.
Table 4.
Addresses
Keypad
Part 1
1
192
2
200
3
208
4
216
5
224
6
232
7
240
8
248
Part 2
Part 3
193
194
201
202
209
210
217
218
225
226
233
234
241
242
249
250
Enter location, then # (2)
Part 4
Part 5
195
196
203
204
211
212
219
220
227
228
235
236
243
244
251
252
, it is reminding you that
Part 6
Part 7
197
198
205
206
213
214
221
222
229
230
237
238
245
246
253
254
Part 8
199
207
215
223
231
239
247
255
Advertisement
Table of Contents
