Nilfisk-Advance Advance SC351 Use And Maintenance

Use and Maintenance
- SC351
ATTENTION! Do not use the machine before you have read and understood the User Manual
1. Disconnect the battery charger cable 2. Fill the tank with a solution suitable
from the electrical main. for the work to be performed.
6. Press the enabling push-button to- 7 . Press the solution flow control
gether with the brush levers to en-
gage the brush/pad-holder and then
release it.
11. Wash with clean water the recovery 12. Wash with clean water the vacuum
tank.
16. Clean the machine using a damp 17. Charge the batteries: Connect the
cloth and where needed use a neu-
tral cleaning product.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this
procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Nilfisk A/S Tel.: +45 43 23 40 50
Kornmarksvej 1 Fax: +45 43 43 77 00
DK-2605 Brøndby mail.com@nilfisk.com
Denmark www.nilfisk.com
3. Always follow the dilution instruc-
tions on the label of the chemical
product used to prepare the
solution. The solution temperature
must not exceed 40°C and be none
foaming
8. Press the enabling push-button to-
switches as necessary, depending gether with the brush levers for start-
on the type of cleaning to be ing floor cleaning. If solution applied
performed. flows outside the brush housing dur-
ing use, reduce the flow of solution.
13. Remove the brushes and clean
grid.
them.
18. Park the machine with the recovery
battery charger cable from the elec- tank cover open.
trical main.
All manuals and user guides at all-guides.com
4. Place the brushes or the pad-holders
under the deck. Use the appropriate
brushes to clean the floor.
9. Turn the knob to "0" position to
switch off the machine.
14. Take the squeegee off and remove
debris.
5. Turn the knob on one of the
indicated programs
10. At the end of the work. Empty the
recovery. Then empty the solution
tank.
15. Check and clean the squeegee
blades.