Nilfisk-Advance SC351 Use And Maintenance

Use and Maintenance

- SC351
ATTENTION! Do not use the machine before you have read and understood the User Manual
1. Disconnect the battery charger cable
from the electrical main.
6. Press the enabling push-button to-
gether with the brush levers to en-
gage the brush/pad-holder and then
release it.
11. Wash with clean water the recovery
tank.
16. Clean the machine using a damp
cloth and where needed use a neu-
tral cleaning product.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this
procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Nilfisk A/S Tel.: +45 43 23 40 50
Kornmarksvej 1 Fax: +45 43 43 77 00
DK-2605 Brøndby mail.com@nilfisk.com
Denmark www.nilfisk.com
2. Fill the tank with a solution suitable
for the work to be performed.
7 . Press the solution flow control
switches as necessary, depending
on the type of cleaning to be
performed.
12. Wash with clean water the vacuum
grid.
17. Charge the batteries: Connect the
battery charger cable from the elec-
trical main.
3. Always follow the dilution instruc-
tions on the label of the chemical
product used to prepare the
solution. The solution temperature
must not exceed 40°C and be none
foaming
8. Press the enabling push-button to-
gether with the brush levers for start-
ing floor cleaning. If solution applied
flows outside the brush housing dur-
ing use, reduce the flow of solution.
13. Remove the brushes and clean
them.
18. Park the machine with the recovery
tank cover open.
4. Place the brushes or the pad-holders
under the deck. Use the appropriate
brushes to clean the floor.
9. Turn the knob to "0" position to
switch off the machine.
14. Take the squeegee off and remove
debris.
5. Turn the knob on one of the
indicated programs
10. At the end of the work. Empty the
recovery. Then empty the solution
tank.
15. Check and clean the squeegee
blades.