Osburn 1700-I Owner's Manual page 25

9. Center the insert into the fireplace opening.
If necessary, adjust the height of the insert using the leveling bolts (DD) on each side of
the convection air jacket until the faceplate is properly seated on the floor of the hearth
extension.
10. Align the notch in the faceplate extension with the bolt (CC) welded to the air jacket located
and slide the faceplate assembly just over the bolt's head and washer (BB). Then push towards
the fireplace.
11. Once the faceplate is in place, secure the assembly by tightening nuts (AA) using a 7/16"
(11 mm) open end wrench.
Product Specification Manual - Osburn 1700-I
AA
BB
CC
DD
Page 25