Conair CTS 5 User Manual page 67

Conair Servo
Traveling Saw
Operator Control
Instructions
Maint. Area
There are three sub-menus, Dirctn, P/M, and Table
accessible in the maintenance area.
S E L E C T M A I N T . A R E A
D i r c t n
Exit or Prev- Pressing Exit or Prev will return the display
to the Menu Area screen.
D i r c t n S o f t k e y
By pressing the soft key located under the word Dirctn on
the Maint. Area Screen, the direction of the encoder can be
changed.
C O U N T D I R E C T I O N I S C O U N T D I R E C T I O N I S
I N C O R R E C T I N C O R R E C T
Located on the lower left side of the display is the status
text (INCORRECT/CORRECT) for the encoder direction.
Exit or Prev- Pressing Exit or Prev will return the display
to the Maint. Area screen.
Change Softkey
With the machine stopped, by pressing the soft key located
under the word Change. The direction of the encoder is
reversed. After the change if the count direction is positive,
the status text will now display the word CORRECT.
Appendix B-1 (11)
P / M T a b l e
C h a n g e C h a n g e