Checking The Encoder - Conair CTS 5 User Manual

C
HECKING THE
E
NCODER
6-8
T
ROUBLESHOOTING
When the encoder is working properly, the encoder LEDs on
the control panel light or flicker as the encoder wheel moves
and generates signals. If the LEDs do not light when the
encoder wheel moves:
1
Check all connections.
2
Check the encoder cable for damage.
sary, replace.
3
Check the connector that attaches the cable to
the encoder.
Internal wiring may be shorted out if this
connector is not handled properly.
4
Check the encoder itself.
in the shaft.
WARNING: Delicate equipment
The encoder is a delicate piece of equipment.
Any rough handling can damage fragile parts.
5
If all else fails,
Appendix page A-1.
CTS Saw
There should be no play
contact Conair Customer Service. See
If neces-
UGE058/0803