Conair CTS 5 User Manual page 60

Conair Servo
Traveling Saw
Operator Control
Instructions
Power Up Sequence
At power up a series of system screens briefly appear. The
software is Red Lion's Edict-97. This screen or similar
shows first.
E d i c t - 9 7 R u n t i m e
V e r . 5 . 0 5 . 1 1 7
Next, the Communications message appears
* * S T A R T I N G C O M M S * *
If there are any problems with communications, this screen
will remain on longer than a couple of seconds.
If there are no communication problems the Conair Servo
Traveling Saw program will begin to run. The following
C O N A I R S E R V O S A W
V e r s i o n 1 . 1
message or similar shows for 5-seconds.
After the 5 second delay the Main Screen will appear.
Appendix B-1 (4)